Mounting Guide: Fendt 900,1000-Series
- Installation time: Approx 5-minutes
Things you will need to install the CabTable™ in a Fendt 900,1000-Series is:
1x Powerdrill
1x Torx 25 bit
1x Torx 20 bit
1x 17mm Wrench
1x Fendt 900,1000-Series mounting bracket and CabTable™
Watch the mounting guide here:
Step 1 Remove the "plug":
Start by removing the "plug" in the pillar with a Torx 25.
Step 2 Position and mount the bracket:
Position the bracket against the post and securely tighten the included 10mm bolt using a 17mm wrench. *Remember to tighten the bolt well*
Step 3 Screw on your CabTable™:
With the bracket now securely mounted, proceed to attach the table by screwing the 4 included screws through the designated holes underneath the table for a stable and secure fit.
Step 4 Final Check:
Ensure all screws and bolts are tightened securely.
